Miller EnPak Mechanic OM-240 113H, Owner'S Manual

Page: 31 / 90

OM-240 113 Page 27
Table 6-1. Engine Error LED Blinking Pattern
Engine errors will cause the engine to shutdown. In Manual mode, the LED will continue to blink until power is turned off and back on. In Remote mode,
the LED blinks for approximately 5 seconds; however, the error message associated with the error flashes on the alpha
− numeric display for one
minute.
.
If error message appears, consult troubleshooting section for remedial actions.
Blinking Pattern Symptom Error Message Remedy
1 Long − 1 Short Engine over speed OVErSPEEd Check actuator
1 Long − 2 Short Low oil pressure LOW OIL Check oil pressure sensor
1 Long − 3 Short Low battery voltage NoCHARGE Check alternator terminal L
1 Long − 4 Short High coolant temperature HiTEMP 1 Check coolant temperature
switch
1 Long − 6 Short High coolant temperature HiTEMP2 Check coolant temperature
sensor
2 Long − 1 Short Abnormal engine speed SPd SENS Check engine speed sensor
2 Long − 2 Short Engine does not run properly GovCNTRL Check actuator for current prob-
lem
2 Long − 4 Short No coolant temperature signal SEN OPEN Check coolant temperature
sensor for open − circuit
2 Long − 5 Short Coolant temperature signal al-
ways on
SENSHORT Check coolant temperature
sensor for short − circuit
2 Long − 6 Short Connection at alternator terminal
L open
ALTRNATR Alternator disconnected at
terminal L
2 Long − 7 Short Battery voltage too high HiVOLTiN Check alternator
2 Long − 8 Short Battery voltage too low LoVOLTiN Check alternator
Notes