Miller Auto Invision 2, Owner'S Manual

Page: 68 / 128

OM-196 188 Page 62
1 No Reset
Press Parameter Select button to
exit memory reset parameter with-
out resetting any data.
2 Program Reset
Press Parameter Select button to
reset last active program to original
factory program settings. All other
program and setup information
remains the same. If setup card is in
card slot, program will be loaded
from card.
3 System Reset
Press Parameter Select button to
reset programs and setup to
original factory settings. System,
Arc Time, and Robot Control
settings are not affected by the
system reset. If setup card is in
card slot, program will be loaded
from card.
4 Total Reset
Press Parameter Select button to
reset programs and setup to origi-
nal factory settings for all programs
and setup including System and
Arc Time. If setup card is in card
slot, program will be loaded from
card.
5 Reset (Default) Displays
Wiretype
Display
> Memory
Shutdown
> No Reset
> Program 1
Reset
Press
> Process
Sequence
SharpArc
Card
> Prg 1
Pulse
035” Steel
Argon – Oxy
1
2
5
> System
Reset
Press
3
11-12. Resetting Memory
Press Mode
Select
Parameter
Select
Increase/
Decrease
Parameter
Select
Increase/
Decrease
Access
Setup
Display
> Total
Reset
Press
4
Parameter
Select
Increase/
Decrease
1 Voltage Shutdown Display
With Arc Start/Volt Sense on, the
unit shuts down when no arc
voltage is sensed. If the unit shuts
down, an error message appears
(see Section 13-5).
With Arc Start/Volt Sense off, the
unit continues to feed wire even
when there is no arc voltage
sensed.
Display
Memory
> Shutdown
Name
Arc Start/
Volt Sense
> On
1
Arc Start/
Volt Sense
> Off
11-13. Selecting Arc Start/Volt Sense Error Shutdown
Press Mode
Select
Increase
Access
Setup
Display