Instruction Manual
Page 15
CHAPTER 7
ADJUSTMENTS
7.0
Adjustments
Wedge Left/Right Alignment
Before checking the wedge alignment, set the speed control
to its lowest setting, the drive delay to its highest setting, and
close the weld rollers.
1. Swing the wedge into place by depressing the drive foot
pedal or the start button. Once the wedge swing has reached
the weld position, view the placement of the wedge with respect
to the weld rollers then release the drive foot pedal or depress
the stop button.
2. The squareness alignment of the wedge must be on center
line with the weld rollers.
3. If the squareness of the wedge is rotated off the center line of
the weld rollers an adjustment will be required.
4. To adjust the wedge squareness, the wedge must first be in
the home position.
5. Locate and loosen the left/right adjustment locking bolts
and adjust the wedge system rotation depending on required
position of the wedge to the weld rollers.
6. After adjustments have been made, re-check the position of
the wedge with respect to the weld rollers. See step one.