Miller Electric Auto-Axcess 450, Owner'S Manual

Page: 27 / 68

OM-210 540 Page 23
4-1 . Operational Terms (Continued)
Start Provides voltage/arc adjust, wire feed rate, and time value for modified arc starts (only available on Auto Axcess
models in the Arc On and Analog input or the Arc On and No Analog input modes, and can only be set with the
optional PDA with File Management software).
Weld Sequence function that allows for a timed weld operation [(0 to 999 seconds) only available on Auto Axcess
models in the Arc On and Analog input or the Arc On and No Analog input modes, and can only be set with the
optional PDA with File Management software].
Crater Allows setting of voltage/arc adjust, wire feed rate, and time value for arc ends (only available on Auto Axcess
models in the Arc On and Analog input or the Arc On and No Analog input modes, and can only be set with the
optional PDA with File Management software).
Postflow Setting a time value for gas flow after arc end (only available on Auto Axcess models in the Arc On and Analog
input or the Arc On and No Analog input modes, and can only be set with the optional PDA with File Manage-
ment software).
Retract Sequence function that allows the wire to move back towards the contact tip when a welding operation is
completed. Setting is both speed (IPM) and time (sec), (only available on Auto Axcess models in the Arc On
and Analog input or the Arc On and No Analog input modes, and can only be set with the optional PDA with File
Management software).
Auto Thread Method of jogging wire without holding jog or trigger switch. Pressing Jog and Retract simultaneously will
automatically feed wire. Default setting is 72 inches at a feed rate of 700 ipm. Pressing jog, purge, or trigger
switch will terminate the auto-threading feature. These values can be changed using a PDA with File
Management/WaveWriter software.