Main Assembly
17. Return to the horizontal stabilizer,
previously assembled in sections 1. thru 8.
Depending on which side you chose to
install the control horn, depends on which
side you install the tail support bracket.
WITH THE CONTROL HORN ON THE
OTHER SIDE OF THE STABILIZER
carefully cut the covering away from the
slots in the stabilizer by using a sharp
modeling knife. Install the mount into the
horizontal stabilizer using thick, or slow
drying CA glue. The three circles of the tail
support bracket should point to the leading
edge of the stabilizer.
18. Now, slide the fuselage stick into the tail
mount support bracket, and secure using
thin CA glue.
REAR TAIL MOUNT
SHOULD BE 3/8
TH
” PAST THE END OF
THE FUSELAGE STICK.
19. Locate the tail skid slot on the tail mount
bracket. Using a micro drill bit, drill a small
hole through the fuselage stick at the front
of the tail skid slot. Install the tail skid into
the drilled hole and locate in the slot.
Secure with thick CA glue. See next picture:
Drill hole to accept tail skid
Install tail skid into the tail support bracket
And secure with thick CA glue
