11. Assemble the battery mount pieces with
thick CA Glue. Ensure that no excess glue
travels into the holes for the fuselage. Refer
to the picture below:
Main Wing & Fuselage Construction
12. Carefully trim the covering from the servo
mount on the top center of the wing, being
careful not to tear the covering. Trim the
servo mount if necessary. Feed the servo
wire through the hole and install the servo.
Use provided #0 -1/4 black screws to mount
the servo.
13. Take the fuselage carbon stick and slide the
servo mounts previously assembled in #11
onto the fuselage. If necessary, shave a
little material around the holes off the
mounts so that they fit onto the fuselage.
DO NOT
sand or lubricate the fuselage
stick.
14. Mount the servos as shown in the diagram
below. Use provided #0 -1/4 black screws to
mount the servo.
DO NOT
glue the mounts
to the fuselage stick until instructed to do
so.
The servo mounts will accommodate
servos up to 7 grams.
15. Slide the fuselage and servo assembly
through the front wing saddle, carving any
excess from the hole ONLY if necessary.
Feed servo wires through the holes in the
center spar towards the front of the wing.
Refer to the picture below:
16. Slide the rear wing saddle onto the fuselage
stick. Position it just in front of the trailing
edge balsa strip. Using thick C.A glue,
secure it to the
WING ONLY. DO NOT
GLUE TO THE FUSELAGE.
Refer to the
pictures below:
(Below) Installed rear wing saddle
