List of Provided Kit Parts:
1. Fully covered, balsa wood Micro SSX wing
2. Set of 2 covered balsa wood ailerons
3. Covered balsa wood vertical stabilizer and
rudder
4. Covered balsa wood horizontal stabilizer
and elevator
5. Pre-shaped wire landing gear
6. Set of two wheels
7. Set of two pre-shaped wire aileron push
rods
8. Set of two pre-shaped wire rudder and
elevator push rods
9. Set of four micro-control horns
10. Set of two micro-wheel retainers
11. 6 - #0 x ¼” black anodized Phillip’s head
screws for mounting servos.
12. 2 - #1 x ¼” black anodized Phillip’s head
screws for mounting motor.
13. Micro SSX decal
14. 15” long wrapped carbon fuselage stick
15. Set of two plywood motor mount pieces
16. Four-piece plywood servo mount kit
17. Three-piece plywood battery holder kit
18. Five-piece plywood tail mount kit
19. Plywood push rod guide
20. Plywood rear wing saddle
21. Four-piece plywood landing gear mount
22. Small Velcro strap to attach battery.
Additional Items Required:
1. Cyanoacrylate or CA Glue (thin and thick)
2. Hobby knife
3. 80-grit and 100-grit sandpaper
4. Sanding block
5. Hinge tape (recommend 3M Scotch ™ ¾”
Transparent Tape)
6. Double-sided servo tape
7. Ruler
8. Square
9. Razor saw
10. Hand drill or small drill with #56 (.046”) drill
bit.
11. 1/16” drill bit.
12. Micro screwdriver set
13. Micro-receiver (recommend Castle
Creations Berg)
14. *Motor (recommend Hacker A10-12S
brushless outrunner motor, 2900 Kv)
15. *Speed control (recommend Hacker X-5, 5
amps, or equivalent)
16. *Propeller (as recommended by motor
manufacturer)
17. *Three servos (less than 7 grams each,
recommended. Ideal is 4 grams)
18. *Battery (recommend 2-cell lithium polymer
battery, 300-480 mAh) Please adhere to
manufacturer’s safety guidelines.
* These components are included in
MicroSSX Combos which are available
either with or without a battery.
IMPORTANT : DO NOT GLUE UNTIL INSTRUCTED TO
DO SO
DISCLAIMER
:
Millennium R/C assumes no responsibility for any accident or injury to persons or damage to property.
Refer to our website for updates on instructions
www.millenniumrc.com
