30
30
Front Installation
#601SFB Standard Metal Front
1. Fit the lower louver unit using the hinge studs and hinge spacers as shown
in figure 42.
2. Fix the two adhesive backed magnet counter plates to the tabs at the firebox
sides, which line up with the magnets on the lower louver. See figure 42.
3. Fit the two side channels by hooking into the openings at the sides of the
firebox. See figure 43.
4. Attach the upper louver by hooking over the tabs near the top of the firebox
sides. See figure 44.
Spacer
Hinge stud
Magnet
counterplate
Bracket to butt up
to edge of corner
plate
#602CFB Cast Iron Front
1. Attach the bottom casting unit by
hooking it over the lower tabs at the
firebox sides. See figure 45.
2. Attach the top casting unit by hooking it
over the four tabs at the firebox sides.
See figure 46.
Additional Optional 3 or 4-Sided
Trims
1. Slide a corner connection plate into the
channels in the top trim and a side trim.
Butt the two trims together. Fit four grub
screws and tighten to secure the trims
and corner plate. See figure 47.
2. Repeat for the other corner(s).
3. Attach the two trim fixing brackets to the
side trims with three screws each side.
The brackets must butt up to the edges
of the corner connection plates. See
figure 48.
4. Attach the complete trim unit to the
firebox with four screws. See figure 49.
Figure 42 Lower louver & magnet counter plate
Figure 43 Side channel
Figure 44 Upper louver
Figure 45 Bottom casting
Figure 46 Top casting
Figure 47 Trims & corner plate
Figure 48 Trim bracket attachment
Figure 49 Trim installation