22
22
Appliance Preparation
Attaching Rear Ceramic Support
See figure 20.
Fit the rear ceramic support to the firebox back panel with
three screws.
Attaching Appliance to the Framing
See figure 21.
1. Place the heater in position in the framing.
2. Secure the side support angles to the side studding
through two holes each side with the woodscrews
supplied. The top support angle should abut the cement
board but is not fixed to the framing.
3. Check the wall finish requirements with the homeowner.
If necessary, adjust the position of the heater so that the
distance from the front of the heater case to the angles is
suitable for the thickness of the wall finish (e.g. tile, etc.).
Figure 20 Rear ceramic support
Top angle
adjustment
from back
of angle
Adjustable for wall finish
material thickness
between 3/8” and 1-3/16“
(10 mm and 30 mm)
Side angle
adjustment
from inside
firebox
Figure 21 Adjustment for wall finish