11
Development System EasydsPIC6
MikroElektronika
page
5.0. ICD Connector
The ICD connector enables communication between the microcontroller and an external ICD debugger/programmer from Microchip
(ICD2 or ICD3). Jumpers J9 and J10 are used for selecting a pin to be fed with programming signals. For the programming signals
to be sent to the microcontroller, it is necessary to place these jumpers in the appropriate position. The position of jumpers depends
on the arrangement of the microcontroller pins used for programming. Figures below show the position of jumpers J9 and J10
depending on which microcontroller pins are used for programming.
Figure 5-5:
ICD connector’s pinout and designations
External ICD programmer is connected to RB6 and RB7 pins
Figure 5-1
: Pins RF2 and RF3
are used for programming
Figure 5-2
: Pins RB6 and RB7
are used for programming
Figure 5-3
: Pins RB5 and RB4
are used for programming
Figure 5-4
: Pins RF7 and RF8
are used for programming
