Programming manual V1.1
www.parapulser.com
8
6.)
The written numbers (e.g. “
2
” or “
10
”) equals the upgrade-frequency in [Hz].
8.8
Software version [
17
] or serial number [
18
] readout
Software version (
2
-digit) or serial number (
6
-digit) readout:
1.)
Activate
Programming-mode
, see “
8
a)
”
on page
2
.
2.)
Activate Input-mode:
CODE
-key press
2
sec., until
3
“
Piep!
”-tones are audible. The input-mode is now acti-
vated: the
red
LED blinks
1
x per second and in addition a Piep-tone is audible!
3.) 2
-digit number “
17
” (softw. ver.) or “
18
” (ser.-no.) input:
Jump to chapter “
8.13
” on page
11
and follow the instructions for number entering. Af-
terwards it continues here with point
4.)
.
4.)
Write down the displayed numbers:
The
Parapulser
now shows with help of the LEDs (
=
=
=
) the
first
digit of the up-
grade-frequency. Write down this number.
5.)
Readout of remaining digits of software-version or serial number:
rest
-key
short
press, and after each actuation, write down the via LED (
=
=
=
) dis-
played number (
0
–
9
) right beside the already noted number(s).
Repeat this procedure until a long ”
Beeep!
“-tone signalizes, that all digits have been
readout. The input-mode is automatically terminated and all three LEDs (
=
=
=
) light
up again.
If the
2
-digit software version has been readout, the version you get by inserting a dot
( . ) between the two numbers:
Example
: Readout numbers: “
3
” and
“
1
”,
à
software version is “
3.1
”.
8.9
Test-CODE input [
6
]
– The correct input of a
6
-digit CODE-number can be practiced unlimited with the test-
CODE “
627093
”. Thereby the risk of a CODE-lock is lowered, which will be initiated,
when a real CODE-number is entered three times wrongly.
– How the numbers (
0
–
9
) are displayed via the LEDs (
=
=
=
), should have been un-
derstood, to be able to enter the test-CODE successfully, see “
6.1
”, on page
7
at the
Parapulser
manual.
– Test-CODE input abort:
PROG
-key
as often short press
, until all
3
LEDs (
=
=
=
)
light up again.
Test-CODE input:
1.)
Activate
Programming-mode
, see “
8
a)
”
on page
2
.
2.) Attention
: For an explicit identification, that the test-CODE instead of a real CODE-
number is being entered, after each, via
se
t
-key finished digit-input, the yellow LED
(
=
) lights up for
1
second.
If the yellow LED does not light up during point
4.)
, immediately abort the CODE-input
abbrechen (
PROG
-key
2
x
short
press) and start again at point
3.)
.
