Mikas Elektronik Parapulser, Programming Manual

Page: 11 / 13

Programming manual V1.1
www.parapulser.com
10
Readout pulse reservoir:
1.) Activate Programming-mode , see “ 8 a) ” on page 2 .
2.) rest -key short press, and after each actuation, write down the via LED (
= = =
) dis-
played number ( 0 – 9 ) in a row from left to right.
Repeat this procedure until a long “ Beeep! ”-tone signalizes, that all digits have been
readout. The input-mode is automatically terminated and all three LEDs (
= = =
) light
up again.
The noted number sequence, e.g. 12345678 , represents the exact amount of magnetic
pulses, which are in the pulse reservoir. At empty pulse reservoir, the number “ 0 ” will be
readout.
8.11 CODE-number input
Attention! If a CODE-number has been entered 3 times wrong in a row, the Parapulser
blocks any further CODE-input (CODE-lock). Then, refilling the pulse reservoir or increasing
the upgrade-frequency is no longer possible. A CODE-lock can be unlocked only with an
un -
blocking -CODE, see “ 8.12” below.
To avoid a CODE-lock caused by false input, it is recommended to practice the CODE-input,
see
“ 8.9” on page 8.
Input of a CODE-number:
1.) Activate Programming-mode , see “ 8 a) ” on page 2 .
2.) Activate Input-mode:
CODE -key press 2 sec., until 3 “ Piep! ”-tones are audible. The input-mode is now acti-
vated: the red LED blinks 1 x per second and in addition a Piep-tone is audible!
3.) 6 -digit CODE-number input:
Jump to chapter “ 8.13 ” on page 11 and follow the instructions for number entering. Af-
terwards it continues here with point 4.) .
4.) Acoustic test result after entering the last CODE-digit:
Æ
When all 6 digit were entered correctly, a “ Dulip! ”-signal is audible,
Æ
When a wrong CODE-number was entered, a “ Beeep! ”-signal is audible, and the
red LED (
=
) lights up for 1 second.
The “ Beeep! ”-signal sounds with red LED (
=
) so often, as the CODE-number
was entered wrongly before (maximum 3 x).
5.) After generation of the acoustic test result, the input-mode is finished automatically
and all three LED (
= = =
) light up again.
8.12 Unblocking-CODE
– A CODE-lock can only be unlocked by entering a 6 -digit unblocking -CODE, which
has to be ordered from your Parapulser salesman. How to input an unblocking -
CODE is described at “ 8.13 ” on page 11 .
– After a correct input of an unblocking -CODE, it is again allowed to enter a CODE-
number 3 x wrongly, until the next CODE-lock happens.
!