Personnel:
n
Trainer
1.
Make sure that the control unit is connected as described in
“Connecting the control unit” on page 82
.
2.
Put the control unit onto the mounting screws of the column
(Fig. 54/4, 5) using the threaded holes on its underside
3.
Tighten both mounting screws (Fig. 54/4, 5) by hand.
4.
Make sure that the control unit sits firmly on the column.
ð
The control unit is now firmly connected to the column.
5.
Plug the mains plug of the power supply into the wall outlet.
6.
Switch on the device with the on/off switch (Fig. 53/3).
It takes approx. 17 seconds after the device has been
switched on before it is ready for use.
7.
Make sure that the main menu is displayed
.
ð
You can now connect the electrodes to the device.
9.3 Individual training settings
The individual adjustment of the device is required to support cor-
rect training techniques, training positions, and training processes.
This is why these settings must always be determined by a trainer.
Every person reacts differently to current intensity. Therefore, the
current intensity must be regulated individually depending on the
respective current sensitivity.
Mounting the control unit on the
column
Fig. 54: Putting on the control unit
Specifying settings
Training with the device
2021-07-28
miha-bodytec II EMS training device
83
