31
MM560 Installation Instructions
1 COM:
Circuit common (reference for all logic input)
• Two (2) terminals to provide extra common connection point.
2 CYCLE:
(Typically for use with doorbell button or hardwired key pad)
• Each activation at this input will cycle the operation as follows:
….→ OPEN → STOP → CLOSE → STOP → OPEN → …
3 SAFETY:
(Typically for use with photo beam device, loop detector
or other non-contact sensors)
• Activation of this input while the gate is closing will cause the gate to
stop and return to the opened position.
• Activation of this input while the gate is opening has no effect (gate
will continue to open).
• Activation of this input while gate is idle will prevent gate from closing.
4 EXIT:
(Typically for use with exit loop or wand)
• Activation of this input will open the gate if it’s not already at the
open position
• Activation of this input while at open limit will restart the auto close time
(if enabled).
NOTE:
if the contact (activation) is maintained it will hold the gate in the fully open position.
5 SHADOW:
(Typically for use with loop detector device)
• This input is only monitored when the gate is at the fully open
position. At any other position, activation of this input has no effect on
gate operation.
• Activation of this input while gate at the fully open position will
prevent gate from closing.
6 CLOSE EDGE:
(Typically for use with safety edge device)
• Activation of this input while the gate is closing will cause the gate to
stop and reverse direction for approximately 2 seconds.
• Activation of this input while the gate is opening has no effect (gate will continue to open).
• Activation of this input while gate is idle will prevent gate from closing.
7 OPEN EDGE:
(Typically for use with safety edge device)
• Activation of this input while the gate is opening will cause the gate to
stop and reverse direction for approximately 2 seconds.
• Activation of this input while the gate is closing has no effect (gate
will continue to close).
• Activation of this input while gate is idle will prevent gate from opening.
1
2
3
4
7
5
6
B
AT
T-
1 2 3 4
ON
RECEIVER
LEARN
MAST LIMIT
LEARN
SL
V LIMIT
S3
S4
ALM
S2
OFF
SOFT ST
AR
T OFF
W
ARNING OFF
OPEN PULL
SL
V OPEN DL
Y.
MODE1 OFF
MODE2 OFF
ON
ON
PUSH
SIMUL
T.
ON
ON
120
MIN
MA
X
CHAR
GING
PWR IN
GT
O R
CVR.
WHT
BLU
BRN
ORG
RED
BLK
GRN
WHT
BLU
BRN
ORG
RED
BLK
GRN
COM
GRN
BLK
RED
CYCLE
SAFETY
EXIT
SHADOW
OPEN
EDGE
COM
LOCK
PWR
AU
X
R
LY
PO
WER
INPUT
S
C
ONTR
OL
INPUT
S
MASTER C
ABLE
SL
A
VE C
ABLE
C
ONTR
OL INPUT
S
CLOSE
EDGE
G
TO
LOCK
AU
X
1
2
3
4
5
6
7
NOTE:
• All control inputs are dry-contact, normally open, inputs. DO NOT apply external voltage sources to these inputs.
• All inputs are connected with respect to
COMMON
terminal.
• The status light will blink once when its corresponding input is activated.
Input Connections
Connecting Additional Devices
