38
BA_Lötstar_EN_Vers.07.2016
© MIG·O·MAT GmbH
8.2
Service indications (display)
During operation of a soldering unit the anodes and cathodes
wear out. Therefore, the gas drawing hours are measured by
the control of the unit to ensure safe operation.
The service level can be called by switching over the display.
Press the key
at the operating panel to indicate the gas
drawing hours and the service level:
„100 %“ service level is the standard status of the unit when
delivered or when the unit has been serviced. The reactor
requires to be serviced and inspected every two years, or when
the service level „0 %“ is indicated.
When the unit must be serviced, this is indicated by a signal
tone and by the display:
Service interval
has run down!
The signal tone can be silenced by pressing any key. Operation
of the unit may continue for a limited period of time.
Please contact your supplier or the manufacturer.
Caution: The manufacturer cannot be held liable for any
damage on persons, or for damage on the equipment
caused by operation of the unit after the service interval
has run down!
8.3
Malfunctions and warnings
In case of malfunctions of the unit caused by thermal
overcharging or overpressure, the gas production is
automatically stopped: the unit changes the set value to zero. A
signal tone indicates the malfunction. The valve at the handle
piece should be closed quickly. The signal tone can be silenced
by pressing any key.
If the main transformer is overloaded, the display shows the
following malfunction:
Transf. overload!
Let cool down!
Operation can be continued only after the transformer has
cooled down. For this, change the set value back to the
required value.
Show service level
