Mier Drive-Alert DA-700, Instruction Manual

Page: 16 / 20

False Alarms No Detection or
Intermittent Detection
Check the sensor/transmitter
placement to make sure it is
mounted securely, and not in a
tree if a DA-610TO (this is ok if
using a DA-611TO).
Check the sensor/transmitter to
make sure it is not on the same
address code as a system at a
neighbor’s home.
Remove all accessory wires from
the terminal block.
Call Mier Products’ Free Tech
Support. They will work with you
and might recommend returning
the system to Mier Products for
diagnosis and repair.
Panel is quiet:
replace the
accessory
Check the sensor/transmitter
placement - 50’ (min) away from
the street, power/phone lines.
Move sensor or reduce
sensitivity.
Existing New
Accessory
Defective
OK
OK
OK
Still Not Fixed
Existing New
OK
Check the batteries, Power is
ON
Check sensor/transmitter
sensitivity at or near MAX on
the Sensitivity Adjustment in the
lower right corner
OK
Check sensor/transmitter
and Control Panel address
codes to make sure they match
OK
Check for metal obstructions,
sensor/xmitter 5’ MAX from 10’
drive edge, vehicle does not
pass between transmitter &
receiver
OK
If using more than one sensor/
transmitter, make sure they are
more than 20’ apart
OK
Check that All Detect red LED,
RL5/D12 on in the Control Panel
when a detection and
transmission was to occur.
Note: listen for a Relay “click.”
OK
If using a long-range reception
antenna, check connections and
orientation (horizontal and long
end pointing toward transmitter).
Call Mier Products’ Free Tech
Support. They will work with you
and might recommend returning
the system to Mier Products for
diagnosis and repair.
Still Not Fixed
Check POWER and LO BATT
LEDs on the control panel.
If LO BATT replace the batteries.
If no POWER LED....
No Alert or
Relay Click
Trigger sensor
by passing a
steel tool by it
Return to Mier
Products for
Repair
Check the All
Detect red
LED, RL5/D12
No Alert but
Relay Clicks
Alert Sounds or
Relay Clicks
Still no Alert
Return to Mier
Products for
Repair
Free LifetimeTechnical Support
800-473-0213 ~ info@mierproducts.com ~ www.mierproducts.com
Turn off the Transmitter and
check the Control Panel/Re-
ceiver. If false alarms are still
occuring it is possible there is
some interference inside the
home/business.
OK
If MUTE LED is on, reset by
turning off power and turning it
back on.
OK
OK
If two or more sensor/
transmitters are being used, and
they are activated at the same
time, the system will not respond
with a chime.
16
DA-700 and DA-700-611 Troubleshooting continued
16
DA-700 and DA-700-611 Troubleshooting continued