ATTENTION: THERE IS NO NEED TO DRILL HOLES INTO THE ENCLOSURES TO MOUNT THE
POLE-MOUNT KITS. PLEASE SEE INSTRUCTIONS BELOW.
•
For
poles that are 6” in diameter to 12”,
our Pole-Mount Kits use two (2) heavy-duty
adjustable bands which fit inside the rails across the top and bottom of the enclosure
and fit between the enclosure and the pole as pictured on the left and below.
Part numbers for these kits are the BW-24PM6 (6” to 8” poles), BW-24PM8 (8” to 10”
poles) and BW-24PM12 (10” to 12” poles)
Example of a
Pole-Mount Kits for
6” to 12”
diameter poles
Pole-Mount Kits for 24” Wide METAL enclosures on 6”-12” Poles
1-800-473-0213 ~ www.mierproducts.com
Mier Recommends using at least two people to pole-mount
heavy enclosures, and performing steps 1-4 PRIOR to going to
job site.
1) Mark the center point of each Mounting Rails (A).
2) Slide the Adjustable Band Guides inside both Mounting
Rails, and center them to the point marked on step 1 (B).
3) Place the 1/4” x 20 Screws and 1/4” Washers
on the outside
of the Mounting Rails, run the bolts through the Mounting Rails
and Adjustable Band Guides, and secure with the 1/4” x 20
locknuts
on the inside
(C and B).
4) Insert the two (2) Heavy-Duty Adjustable Bands into the
two (2) Adjustable Band Guides inside the Mounting Rails.
The bands should curve outwards, away from the inside of the
Mounting Rails. One (1) of these Heavy-Duty Adjustable Bands
goes in each of the Adjustable Band Guides assembled inside
each of the Mounting Rails (D).
5) Attach the two (2) assembled Pole-Mount Rails onto the two
(2) Mounting Lips of the Enclosure using the four 3/8” x 16
Carriage Bolts entering through the
inside of the Mounting Rail
,
use TWO (2) of the eight 3/8” EXTRA THICK Washers
ON EACH
bolt between the rail and the enclosure lip for proper spacing,
then use the 3/8” Standard Washers on the
outside of the Enclo-
sure Lip
with the 3/8” flange-nuts (E).
6) Wrap the bands around the pole and use a power driver with
a straight blade screw-driver, or a 3/8” socket fitting, to tighten
the bands securely around the pole (F).
F
C
D
A
E
B
These pole-mount kits are used with the following Mier Products Enclosures:
BW-1248BP, BW-1248FC, BW-1248ACE, BW-1248ACHT, BW-124BP, BW-124FC,
BW-124ACE, BW-124ACHT, BW-136BP, BW-136FC, BW-136ACE, BW-136ACHT,
BW-RACKACE and BW-RACKACHT
