Problem solving guide
The Pre-wash indicator light
i
is flashing:
Start the programme again. If the indi-
cator still flashes call the Service De-
partment.
The Main wash indicator light
j
flashes during, or after the
end of a programme.
If it flashes the next time the machine is
switched on there is a technical fault.
Call the Service Department.
Despite adequate water supply
pressure, the machine takes a
long time to fill.
Clean the filters in the water inlet sys-
tem as described on page 28.
Large amounts of unused
detergent remain in the dispen-
ser drawer.
Water supply pressure is too low.
Clean the filters as described on
page 28.
Check if the water flow through the
stopcock is 5 litres in 15 seconds.
Washing powder becomes viscous
when used together with a water sof-
tener.
In future pour washing powder into
the detergent dispenser before ad-
ding water softener.
Fabric conditioner is not com-
pletely dispensed or water re-
mains in the
p
compartment.
The dispenser drawer was opened
while fabric conditioner was being
flushed in.
The siphon tube is either incorrectly po-
sitioned or clogged. Clean as des-
cribed on p. 25.
30
