Problem solving guide
Any work on the electrical compo-
nents of this appliance should only
be carried out by a suitably quali-
fied and competent person in ac-
cordance with local and national
regulations. Unauthorised repairs
could be dangerous.
There are, however, minor faults which
can be corrected without contacting
the Service Department.
A selected programme does
not begin
The I/
h
On/Start indicator light does
not light up.
Check that:
the door is properly closed,
the mains plug is plugged in and
that the fuse or circuit breaker has
not tripped.
Check warning lights
pq
The
p
check light flashes, although
the programme has finished as usual.
The water inlet system is blocked:
Stopcock(s) not fully opened.
Inlet hose(s) kinked or trapped.
The water pressure is too low.
The filters in the inlet hose(s) are
clogged (see “Cleaning and Care”
on page 28).
The indicator light goes out when the
programme selector switch is turned to
the
r
End position.
The check light
p
flashes, the End
indicator light is on, but the laundry
in the machine has not been washed.
The water inlet system is blocked.
Turn the programme selector switch
to
r
End.
Turn on the water supply at the stop-
cock(s).
Select a programme.
Press the “Start” button.
If little or no water is taken in during the
next programme, the water pres-sure
may be too low. If it is adequate there
may be a technical fault. In this case,
call your local service dealer or the
Miele Service Department.
The
q
indicator light is flashing
Check whether
the drainage system is clogged.
Clean as described on pages 26/27
if necessary.
29
