A fault indicator light comes on but the wash programme con-
tinues as normal.
Fault indicator
Possible cause
Remedy
A
The Check drain
light flashes.
The drain outlet is
restricted.
Clean the fluff filter and the drain
pump as described in "Problem
solving guide - Opening the door in
the event of a blocked drain outlet
and/or power failure".
The Check inlet light
flashes.
The water inlet is
restricted.
Check whether
–
the stopcock is opened wide
enough.
–
the inlet hose is kinked.
The filter in the wa-
ter inlet hose is
dirty.
Clean the filter.
The Excess
detergent check
light comes on.
Excessive foam
has built up during
washing.
Use less detergent next time and
follow the manufacturer’s
instructions on dosage given on the
packaging.
The Main wash
indicator light is
flashing in the
programme
sequence display.
There is a fault.
Start the programme again.
If the fault indicator occurs again,
contact the Service Department.
The Anti-crease/
Finish indicator light
flashes in the
programme
sequence display.
The position of the programme selector was altered after
the start of the programme. Turn the programme selector
back to the programme previously chosen.
A
To switch off the fault indicator: switch the washing machine off with the I-ON/
0-OFF button and turn the programme selector to
Finish
.
Problem solving guide
40
Summary of Contents for W 489i WPS
Page 67: ...Programmable functions for changing standard settings ...
Page 73: ...73 ...
Page 74: ...74 ...
Page 75: ...75 ...