Before using the machine for the first
time ensure that it is correctly
installed and connected. See
"Installation and connection". Also
check that the fluff filter is securely
tightened to prevent the risk of water
leaks during use.
The washing machine has a sensor
which measures the amount of laundry
in the drum. This determines the
amount of detergent required. To allow
the load size indicator to function
correctly, you must first run a wash
programme without any laundry and
without detergent. The sensor must also
be calibrated to zero as you would with
bathroom scales.
^
Open the stopcock.
^
Press the
I-On/0-Off
button in.
When the washing machine is switched
on for the first time, the welcome screen
will appear.
M
Welcome
The welcome screen will not appear
again once you have set the machine
up for first use as described in this
chapter, or once a programme lasting
longer than 1 hour has been
completed.
The washing machine will remind you to
remove the transport struts.
i
Remove transport
struts
OK
^
Remove the transport struts if they
have not been removed already.
Then confirm this with OK.
The display for setting the clock will
appear.
12
: 00
Set time of day
^
Set the hour with the
–
and
+
buttons
and confirm your setting by pressing
the OK button. Now set the minutes.
After you have confirmed the minute
setting, the display will change to
show the entry menu.
15:00
Select programme
^
Turn the programme selector to the
Cottons 60°C
position.
^
Press the
Start/Stop
T
button.
At the end of the programme, the load
size sensor must be re-calibrated to
zero. See next page.
Before using for the first time
11
Summary of Contents for W 2662 WPS
Page 62: ...62 ...
Page 71: ...71 ...
Page 72: ...Alteration rights reserved 5104 W 2662 M Nr 06 068 860 02 en GB ...
