Building under a continuous
worktop / in a kitchen run
– A special building under conversion
kit* is required.
The machine lid must be replaced by
a cover plate. To ensure electrical
safety the cover plate must be
fitted. **
N.B.**
If you wish to push your machine under
a worktop and there is space to do this
without removing the lid
, the
conversion kit is not necessary.
Otherwise the conversion kit is
essential.
– For installation under a work surface
900/910 mm from the floor, a raising
kit* is required.
– Connections for electricity, water and
drainage should be installed in such
a way that they remain accessible
when the machine is in place.
Fitting instructions are supplied with the
conversion kit.
All parts marked* are available from the
Miele Spare Parts or Sales Department.
The fitting of cover plates and
stacking kits must only be
undertaken by qualified and
competent persons, in accordance
with the instructions supplied with
the kit.
Washer and Dryer stack
A Miele tumble dryer can be stacked
with the washing machine. A stacking
kit* is necessary and can be purchased
from the Miele Spare Parts Department.
Please note
a
Safety distance to wall:
at least 2 cm
b
Height:
Stacking kit with pull-out shelf:
approx. 169 cm
Stacking kit without pull-out shelf:
approx. 170 cm
,
A washer and dryer should
never be stacked without using the
proper stacking kit. Doing so is
extremely dangerous, as the dryer
may vibrate off of the washing
machine during use.
Installation and connection
48
Summary of Contents for W 2104
Page 55: ...Programmable functions for changing standard settings ...
Page 62: ...62 ...
Page 63: ...63 ...
Page 64: ...Alteration rights reserved 1005 M Nr 06 036 350 02 en AU ...