Cleaning the water inlet filters
The washer has two water inlet filters to
protect each inlet valve. These filters
should be checked and cleaned if
necessary every 6 months. This may
need to be done more frequently with
some water supplies.
^
Turn off the water supply.
^
Unscrew the inlet hose from the valve
by turning the connector counter-
clockwise using a wrench if
necessary.
^
Remove the rubber seal,
1
, from the
connector.
^
Using needle nose pliers, grasp the
plastic filter,
2
, and pull it out of the
hose connector.
^
Clean the filter under running water
and carefully remove any large
particles.
^
Replace the filter and seal then
reconnect the hose.
^
Slowly turn on the valve and check
for leaks. If water leaks, tighten the
bolt.
Both filters
must
be put back in
place after cleaning.
Cleaning and care
26
Summary of Contents for TOUCHTRONIC W 4800
Page 40: ...36 ...
