Installation site
For best performance front loading
washers should be installed on the
ground floor or basement of the
building.
A concrete or reinforced floor is the
most suitable surface for the washer.
These floors are less prone to vibration
during the spin cycle.
If the installation must be on a wooden
joist floor:
– the corner of a room where the
stability of the floor is at its greatest is
the best place to install the washer.
– the machine must be leveled and
securely positioned.
– to avoid vibration while spinning, the
machine should not be installed on
soft floor coverings.
^
Install the unit on a 1
1
/
4
" (32 mm)
thick, 28" x 31" (71x78 cm) wide
plywood base. Ideally the base
should be large enough to span
several joists and should be
anchored to the joists and not just the
floor boards.
,
If the machine is installed on a
raised platform it must be secured
with retaining clips available from
your dealer or Miele.
If installed on a masonry or concrete
base, the base should have a ½"
(13 mm) to ¾" (19 mm) high rim.
This must be done to prevent the
washer from vibrating off the stand
during the spin cycle.
Installation
^
Use the front washer feet and the
rear excess end to transport the
washer from its shipping pallet to the
installation site.
Do not lift the washer by the drum
door!
,
Ensure that the machine’s feet
and the floor are dry to prevent
slippage during the spin cycle.
Installation
40
Summary of Contents for TOUCHTRONIC W 4800
Page 40: ...36 ...
