Miele SGJA0, Operating Instructions Manual

Page: 82 / 96

Cleaning the roller on the AllTeQ
floorhead (dia. 37)
a
Release the bearing (with bayonet
fitting) using a coin.
b
Press the bearing out, and remove it.
c
Take out the roller.
^
Remove any threads and hair, repla-
ce the roller and refit the bearing.
Replacement parts are available from
your Miele retailer or from Miele (see
back cover for contact details).
Cleaning and care
,
Always disconnect the vacuum
cleaner from the electrical supply
before cleaning it. Switch off at the
wall socket and unplug it.
Vacuum cleaners with textile velvet
finish
Clean the vacuum cleaner casing with
the dusting brush or a slightly damp
cloth.
Vacuum cleaner and accessories
External surfaces of the vacuum
cleaner and of the accessories can be
cleaned with a proprietary cleaner
suitable for plastic.
,
Do not use abrasive cleaning
agents, glass cleaning agents,
all-purpose cleaners or oil-based
conditioning agents.
Dust compartment
The dust compartment can, if
necessary, be cleaned using a
dry
duster, brush or, if available, a second
vacuum cleaner to vacuum the dust
out.
,
Warning: Do not let the vacuum
cleaner get wet. If moisture gets into
the appliance, there is a risk of
electric shock.
Problem solving guide
The vacuum cleaner switches off
automatically. The overheating
warning light
,
also comes on
(dia 38).
A temperature limiter switches the
vacuum cleaner off automatically if it
gets too hot. The overheating warning
light
,
will then come on to indicate
that it has overheated.
This can occur if, for instance, large
articles block the suction tube or when
the filter bag is full or contains particles
of fine dust. A heavily soiled dust
compartment or exhaust filter can also
be the cause of overheating. Switch the
vacuum cleaner off immediately using
the On/Off foot control
s
. Disconnect it
from the electricity supply. Switch it off
at the wall socket and unplug it.
After removing the cause, wait for
approx. 20 - 30 minutes to allow the
vacuum cleaner to cool down. It can
then be switched on again.
en
82