To avoid the risk of damaging the
appliance fit the wall units and
extractor hood before installing it.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This appliance must not be used in
a non-stationary location (e.g. on a
ship).
~
The Salamander must not be
installed directly next to a barbecue
grill (CS 1312 / CS 1322) or a Tepan
Yaki (CS 1326 / CS 1327). It is essential
to maintain a distance of at least
150 mm between these two appliances.
~
After installation, ensure that the
connection cable is without hindrance
and that there is no mechanical
obstruction which could damage it.
~
To prevent the risk of heat damage
to the electrical cable, please ensure it
installed in such a way that it cannot
touch any parts of the appliance which
become hot.
~
Do not use any sealant except
where expressly instructed to do so.
The seal underneath the appliance
provides a sufficient seal for the
worktop.
~
Observe carefully the safety
distances given on the following pages.
All dimensions in this instruction booklet
are given in mm.
Safety instructions for installation
22
