en - Operation
62
Start at
Universal
12:30
This activates the timer.
Changing the timer
If you want to change the time set for the
timer, first press the
button to return to
the programme view.
Tap the
symbol. You can then enter a
new start or finish time.
Deleting the timer
Press the
Start/Stop
button.
Start programme
immediately
Delete timer
You can either delete the timer setting (
De-
lete timer
) or delete the timer and start the
programme immediately (
Start programme
immediately
).
Alternatively, you can tap the
symbol
again in the programme view and delete the
timer via the settings that follow.
Programme sequence display
Once a programme has started, the display
shows the programme name, the name of
the current wash phase and the time left un-
til the programme is finished.
Universal
1:14
h
Time left
Pre-wash 1
Programme parameters such as the actual
and target temperature can be queried dur-
ing a programme sequence.
Tap the
symbol.
End of a programme
After a programme has ended normally, the
LED of the Start/Stop button will go out and
the following will appear on the display.
In addition to this, a buzzer will sound for
approx. 3 seconds (factory default setting).
The buzzer is repeated three times every
30 seconds. To change buzzer settings, see
“Volume”.
Tap to acknowledge the display.
If system messages are present, they are
displayed afterwards, e.g. if the salt con-
tainer level or the level of the liquid process
chemicals containers was low during the
programme, or when the next service is
due. Every message needs to be acknow-
ledged individually by pressing
OK
.
Switching off
Press the
button until the display turns
off.
