Technical Information
43
T1500 Series Clothes Dryers
6.3
Fault Codes – T1576
Initial Requirements
1. Switch the appliance On.
2. Turn the Selector Knob to the Cotton Extra Dry position.
3. Press the Start Button to begin the program.
4. Note the status of the Anti-Crease LED.
The Anti-Crease LED is lit
STEADY
No Fault Stored
The Anti-Crease LED is
FLASHING
Fault Stored – Proceed to Access
steps below
Access (Retrieval)
1. Access the Service Mode (6.2)
2. Turn the Selector Knob to Woolens position.
3. Press the Start Button
4. Note the illuminated LED’s.
5. Refer to Table 6-3 to determine the stored Fault.
6. Switch the appliance Off.
7. Perform the necessary service steps to rectify the cause of the
fault; proceed to the “Delete a Stored Fault Code” below.
Delete a Stored Fault Code
1. Access the Service Mode (6.2)
2. Turn the Selector Knob to Woolens position.
3. Press the Start Button.
4. Press and hold the Gentle Button.
5. Press the Start button.
6. Release the Gentle button - the appropriate LED turns off.
7. Switch the appliance Off.
LED
Lit Steady
Component
Rotary Iron
Fan NTC open circuit
Hand Iron
NTC at heater bank open circuit.
Normal
NTC at heater bank short circuit
Rotary Iron & Hand Iron
Fan NTC short circuit
Normal and Rotary Iron
Max drying time exceeded, (180 minutes)
Table 6-3:
Fault Code Storage (T1576)
