Before using for the first time
To ensure the correct functioning of
the appliance, let it stand for between
½ and 1 hour after transporting it to its
final location before connecting it to
the mains.
Protective foil
The stainless steel strips and frames
have a layer of protective foil to prevent
scratching during transportation.
The external surfaces of stainless steel
appliances are also covered with a
protective foil.
^
Remove the protective foil only after the
appliance has been installed in its
intended location.
Cleaning and care
^
Immediately after removing the
protective foil, apply the Original
Miele Care product for stainless steel
(availabe from Miele or at
www.miele.com.au) to stainless steel
strips and frames.
^
Also apply the Original Miele Care
product for stainless steel to the side
panels after removing the protective
foil.
Appliance doors have a special
coating that is not susceptible to
soiling. Do
not
apply this product to
doors.
Important! Each time the Original
Miele Care product for stainless steel
is used, it forms a protective film
against dirt and water.
^
Clean the inside of the appliance and
the accessories with lukewarm water
and then dry with a soft cloth.
Active charcoal filters
(Active AirClean charcoal filters)
^
Place the active charcoal filters
supplied in the holder, and place the
holder on one of the shelves
(see "Active charcoal filters").
Operating the appliance
A light touch of the finger on the
sensors is all that is required to operate
this appliance.
Switching the appliance on
The refrigeration and freezer sections
are switched on together with the
On/Off sensor.
^
Touch the On/Off sensor until the
temperature display lights up.
The temperature display shows the
current temperature in the refrigeration
section.
If the temperature in the freezer is
above 0 °C, lines light up in the
temperature display of the freezer. As
soon as the temperature falls below
0 °C, the temperature display indicates
the current freezer temperature.
The "Freezer" symbol and the Alarm off
sensor will flash until the temperatures
are sufficiently low.
Switching on and off
14