Miele HR 1134-3 AG, Installation Instructions Manual

Page: 16 / 124

Notes on installation
*INSTALLATION*
16
The models described in these
operating instructions can be found at
the end.
Data plate
The data plate is located behind the toe
kick panel. The toe kick panel is
attached to the toe kick of the Range by
magnets so it can be removed and put
back again easily.
There you can find the model number,
serial number and the connection data
(voltage/frequency/maximum rated
load) for your Range.
Have this information available if you
need to contact Miele so that any
issues can be rectified as quickly as
possible.
Distance to the range hood
The minimum clearance between the
appliance and a range hood above will
be listed by the hood manufacturer.
If there is more than one appliance
installed below the range hood, each
with a different safety clearance, the
largest clearance must be used.
Scope of delivery
Toe kick panel and splash guard
30" and 36" Range
These components are located in the
packaging of the Range.
48" Range
These components are pre-
assembled.
Installation of the toe-kick
The toe-kick has sheet metal lugs and
magnets by means of which it can be
positioned and attached to the base of
the range.

Position the toe-kick in such a way
that the sheet metal lugs are facing
the provided holes in the base.

Push the toe-kick onto the base of
the range until it audibly locks into
place.
Installation of the drip tray
The drip tray covers the gap between
the oven cavity and the door.
 Open the oven door.

Lay the drip tray over the gap
between the oven cavity and the
door.

Close the oven door.