Installation, maintenance and repairs
to the electrical components of this
appliance should only be carried out
by a suitably qualified and
competent competent person in
accordance with national and local
safety regulations. Repairs and other
work by unqualified persons could
be dangerous. The manufacturer
cannot be held responsible for
unauthorised work.
Some minor problems however can be
dealt with as follows:
What to do if . . .
. . . the oven does not heat up.
Check whether,
^
the selector switch is set to the
function required,
and
the
temperature control is set at the
correct temperature.
^
the operating lock is activated
(bottom oven).
^
the mains fuse has blown. Contact a
qualified electrician or the Miele Ser-
vice Department.
. . . "12:00" flashes in the timer
display.
This is not a fault.
There has been an interruption to the
power supply. After a power cut
– the time of day has to be entered
again,
– the operating lock has to be
reactivated.
. . . the heating works, but not the
oven lighting.
Make sure the halogen lamp is
connected properly in its socket.
If after checking it, it still does not work
you will need to change it:
^
Disconnect the appliance from the
electricity supply:
Switch off at the isolator or the mains
fuse box.
^
Remove the runners.
^
Lift the lamp cover from its retainers.
^
Replace the halogen lamp:
12 V, 20 W,
heat resistant up to 300°C, G4
socket, Osram, Type 64428.
Exercise caution when changing a
lamp. Halogen lamps get very hot
during use and will remain hot for some
time after being switched off.
Do not touch the surface directly when
changing the lamp as grease particles
from your fingers will adhere to the
surface and damage it. Please follow
the manufacturer's instructions.
Correcting minor faults
49
Summary of Contents for H 348 B2
Page 4: ...Description of the appliance 4 ...
Page 58: ...58 ...
Page 59: ...59 ...
Page 60: ...Alteration rights reserved 22 1605 H 348 B2 H 349 B2 M Nr 05 855 472 00 en GB ...
