Miele G4263, Operating Instructions Manual

Page: 88 / 92

Water connection
88
The Miele Waterproof system
As long as your dishwasher has been
installed correctly, the Miele waterproof
anti-leak system will protect you from
water damage.
Connection to the water supply

Water in the dishwasher must
not be used as drinking water.

IMPORTANT Australia and New
Zealand
This appliance must be installed
according to AS/NZS 3500.1. Back
flow prevention is already integrated
in the appliance.
– The dishwasher may be connected to
a cold or hot water supply, max.
60°C.
We would only recommend
connection to a hot water supply if it
is economical, e.g. a solar powered
supply. When connected to a hot
water supply, all programmes will be
carried out with hot water.
– The inlet hose is approx. 1.5 m long.
– A tap with a 3/4" male thread must
be provided on site.
– Connection to the mains water
supply should only be carried out by
a qualified and competent person in
strict accordance with national and
local safety regulations.
The tap should be easily accessible
once the appliance has been built in.
– The water pressure (flow pressure at
the take-off point) must be between
50 and 1000 kPa (0.5 and 10 bar). If
the water pressure is too high, a
pressure reducer valve must be fitted.
After connecting the dishwasher to
the water supply, check that all
plumbing connections are watertight.

To avoid any damage to the
appliance, the dishwasher must only
be operated when it is connected to
a fully vented plumbing system.

The inlet hose must not be
shortened or damaged in any way as
it contains electrical components
(see illustration).