3. Audible tone (Buzzer)
This special function allows you to
programme a buzzer (lasting up to a
maximum of 30 seconds) for the
following functions:
– Programme end = Constant buzzer
– Fault warning = Buzzer at one
second intervals
– Removing a test item from the final
rinse water (this function has to be
programmed by a Miele service
engineer)
= 3 x short beeps followed by 2
second pause, then 3 short beeps
etc.
^
Turn the programme selector to STOP
f
.
^
Switch off the machine.
^
Press and hold
ß
and
6
at the
same time, and whilst doing so,
switch the machine on with the
I-0
button.
The current programme status "P..."
will appear in the display and the
p
/
6
indicator light will come on.
^
Press
0
four times. E04
(programming level 4) appears in the
display.
^
Turn the programme selector to
q
. A
number from 20 to 27 will appear in
the display.
20 = Buzzer switched off
21 = Buzzer at end of programme
(standard setting)
22 = Fault indication
23 = Fault indication and buzzer at
end of programme
24 = Reminder to remove a test item
25 = Buzzer at end of programme
and for removing a test item
26 = Fault indication and buzzer for
removing a test item
27 = Buzzer for all functions
(Programme end, Fault indication,
Removing a test item).
^
Press
ß
or hold pressed in until the
required value appears in the display.
^
Press
6
. SP appears.
^
Press
6
again. The change has
been recorded.
Value set:
Note:
The buzzer can be switched off early
by
– turning the programme selector to
the STOP position
f
,
– pressing the
ß
button, or
– interrupting the power supply (e.g.
by opening and closing the door).
Programming special functions
37
Summary of Contents for G 7860
Page 27: ...27 ...
