![background image](http://html.mh-extra.com/html/miele/g-640/g-640_operating-instructions-manual_234734051.webp)
Checking the water level
If the water pressure (flow rate at the
take-off point) is less than 1.0 bar, too
little water will flow into the wash
cabinet and the dishes will not be
cleaned properly.
To check whether sufficient water flows
into the wash cabinet:
Turn on the stopcock fully.
Run the “Pre-wash” programme
(without crockery) once to get water
flowing throughout the machine.
Start the “Pre-wash” programme
again.
After approx. three minutes open the
door and remove the bottom basket
from the machine.
The water level is correct when the
water level (dimension
“X”
), is at least
4 mm above the coarse filter in the
middle of the filter combination.
If it measures less, then either the water
inlet filter must be cleaned (see pre-
vious page) or the water intake time in-
creased (see following page).
Solving problems
51