Miele G 1XXX Series, Operating Instructions Manual

Page: 16 / 68

To programme the water hardness
level
Each time a button is pressed, one of
the indicator lights will flash and light
up in the control panel. However, only
the indicator lights mentioned in the
following programming process stages
are significant.
The programming procedure can be
cancelled at any time by pressing the
On/Off button
K
. The procedure can
then be re-started from the beginning
again.
^
Switch the dishwasher off with the
On/Off button
K
.
^
Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button
K
.
Keep the Start/Stop button pressed in
for at least four seconds until the
"Start/Stop" indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
^
Press the programme selector button
twice.
The lowest programme indicator
flashes twice briefly at intervals, and the
Wash/Rinse programme sequence
indicator flashes once at intervals
(factory default setting).
The number of times the Wash/Rinse
programme sequence indicator flashes
tells you the value which has been set
(see chart).
°d mmol/l Wash/Rinse
indicator
flashes:
1 - 4 0.2 - 0.7 Once briefly
5 - 7 0.9 - 1.3 Twice briefly
8 - 11 1.4 - 2.0 3 times briefly
12 - 15 2.2 - 2.7 4 times briefly
16 - 20 2.9 - 3.6 5 times briefly
21 - 25 3.8 - 4.5 6 times briefly
26 - 30 4.7 - 5.4 7 times briefly
31 - 36 5.6 - 6.5 8 times briefly
37 - 45 6.7 - 8.1 9 times briefly
46 - 70 8.3 - 12.6 Once for longer
^
Use the Start/Stop button to select
the number of flashes which equates
to your water hardness level.
Each press of the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
Example:
If your water hardness level is
4.0 mmol/l (22 °d), the Wash/Rinse
indicator should flash briefly six times
at intervals.
^
Switch the dishwasher off with the
On/Off button
K
.
Before using for the first time
16