Cleaning and care
30
Stainless steel frame/control
panel
Clean the frame and the control panel
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.
You can also use a ceramic and stain-
less steel cleaning agent. We recom-
mend also using a stainless steel condi-
tioning agent to help prevent resoiling
(see "Optional accessories).
Do not use ceramic and stainless
steel cleaner or stainless steel condi-
tioning agent on the
printing
.
This would rub the printing off.
These areas should be only cleaned
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.
Operating controls
Clean the control(s) with a solution of
warm water and a little washing-up li-
quid applied with a soft sponge.
Stubborn soiling should be soaked
first.
Dry the control(s) with a clean cloth.
Stainless steel trough
Do not clean the area between the
hob and the worktop with sharp,
pointed objects.
This could damage the seals.
Soiling, particularly salty food or li-
quid and olive oil, can cause damage
if left on the printed surfaces for a
long time.
Remove any soiling which comes
into contact with the printed symbols
straight away.
Stainless steel cleaning agents rub
off the printed symbols.
Do not use stainless steel cleaning
agents on printed symbols.
Clean stainless steel surfaces with a
solution of warm water and a small
amount of washing-up liquid applied
with a soft sponge. In the case of
stubborn dried-on soiling, soak first.
If necessary, the rough side of non-
scouring sponge can be used.
Finally, dry with a clean soft cloth.
Tip:
The Miele conditioning agent for
stainless steel can be used after clean-
ing to help keep your appliance looking
good (see "Optional accessories"). Ap-
ply sparingly with a soft cloth following
the instructions on the packaging.