Cleaning and care
44
Cleaning the plinth filter
Pull the handle out of the plinth filter.
Clean the plinth filter thoroughly un-
der running water.
Squeeze the plinth filter very carefully
several times as you rinse it.
Rinse the plinth filter until all visible
residues have been removed.
Use a damp cloth to remove any fluff
from the handle.
Damage caused by a damaged
or worn plinth filter.
The heat exchanger will clog up if the
plinth filter is not in good working or-
der. This can cause a fault.
Check the plinth filter following the
instructions provided in “Problem
solving guide – Replacing the plinth
filter”. Replace the plinth filter if ne-
cessary.
Fit the plinth filter back on the handle.
Make sure it is the correct way round.
Push the plinth filter in completely.
This will push in the right-hand guide
pin at the same time.
