Problem solving guide
61
Fault message at the end of a programme
Problem
Cause and remedy
Check dosage
Excessive foam has built up during washing.
Use less detergent next time. Follow the manufac-
turer's instructions on dosage given on the pack-
aging.
Hygiene info: run a
programme at min.
75 °C or the “Clean
machine” pro-
gramme
When washing, a wash programme using a temperat-
ure above 60 °C has not been run for a long time.
Turn the programme selector to
Further pro-
grammes
/
.
Touch the
sensor controls until
Maintenance
appears in the display.
Touch the
OK
sensor control.
The following appears in the display:
Clean machine
Touch the
OK
sensor control.
Run the
Clean machine
programme using Miele ma-
chine cleaner or a universal powder detergent.
This will clean the washing machine and prevent a
build-up of bacteria and odours.
Align the washing
machine
The
Pre-ironing
extra option which runs at the end of
the programme could not be carried out properly.
Check whether the washing machine is aligned
correctly (see “Installation – Levelling the ma-
chine”).
Check whether the maximum drain height of 1 m
has been exceeded.
If the fault message appears again, contact the Miele
Customer Service Department. The washing machine
can still be used, but without the
Pre-ironing
extra op-
tion.
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the
OK
sensor control.
