assembly InstructIons
1.
Remove the contents of the packing carton. Sort and identify
all the pieces described in the Parts Identification. (When
packed in the factory, the Corner Rods are inserted into the
loops of the Door Panel and Back Panel.)
2.
Locate the “front” Bottom Panel (A - this bottom panel has
the “pan stop”) and place it flat on the floor with the hooks
of the Bottom Panel extending upward as shown below.
3.
Locate two Side Panels (C) and lay them flat on the floor,
one on each lengthwise side of the Bottom Panel as shown
below. (The loops on the short ends of each Side Panel
should face upward.)
4.
Slightly lift and place the long edge of each Side Panel over
the hooks on the Bottom Panel so that the second rung from
the bottom of each Side Panel overlaps and rests directly
under the hooks of the Bottom Panel.
5.
With the assistance of another person, pull the two Side
Panels outward and upward to form a “U” shape. (Make sure
the second rung from the bottom of each Side Panel slides
up to connect inside the upright hooks of the Bottom Panel.)
6.
Fold the connected panels that make the Top Panel (B) so
that the hooks on the side face outward. Position the folded
Top Panel (B) over the upright Side Panels with the hooks
facing downward. Connect the hooks of the Top Panel to the
top rungs of the two upright Side Panels. (Make sure the
panel is centered between the ends of the side panels.)
7.
Repeat Steps 2 through 5 using the “back” Bottom Panel
(A)--the remaining Bottom Panel.
2
Pan stop
1st Rung
2nd Rung
Lift and slide so that
bottom two rungs
extend over hooks
