www.midtronics.com
MDX-650P SOH
17
Printer Troubleshooting
If the MDX-650P is not connected to a 12-volt battery with at least 11.5 volts of
power or the paper sensor does not detect paper in the compartment during the
print process, the tester displays one of error messages described in the table:
Error Message
Interpretation
PRINTER OUT OF PAPER
REPLACE WITH THERMAL
PRINTER PAPER.
2.5 IN. DIA. MAX
2.25 IN. WIDE MAX
9
Verify that the paper is inserted correctly.
9
Insert a new roll of paper.
9
Verify that the paper sensor is clean and undamaged
BATTERY POWER TOO
LOW TO USE PRINTER.
CONNECT TO FULLY
CHARGED BATTERY.
11.50 V TO 16.00 V
To print, the tester must be properly connected to a vehicle
battery having at least 9 volts.
9
Connect to a vehicle battery with enough voltage to
enable printing.
9
Make sure that the clamps are connected properly: red
clamp to the positive (+) terminal and the black clamp
to the negative (-) terminal.
9
Check that both sides of the clamps are making con-
tact with the terminals.
PRINTER DOOR OPEN
CLOSE DOOR AND TRY
TO PRINT AGAIN
9
Check that the door covering the printer paper is prop-
erly closed and latched.
Troubleshooting the Display
If the display does not turn on:
•
Check the connection to the vehicle battery.
•
The vehicle battery may be too low (below 1 volt) to power the analyzer.
Fully charge the battery and retest.
•
The analyzer’s AA batteries may need to be replaced. (Alkaline recom-
mended).
•
If the analyzer does not power on when you press and hold the button,
replace the AA batteries.
Summary of Contents for MDX-650P SOH
Page 2: ...Blank page...
Page 4: ...www midtronics com MDX 650P SOH 4...
