17
3.4.13 PLACING A CALL, 5Tone Mode
In 5Tone mode, enter the digits in the field indicated by the arrow at the top of the display. To clear the
display, hold the SHIFT key and press the PTT. However, it is not necessary to clear the display. New
numbers entered will replace existing digits. Only digits 1 through 9, 0 and A may be used. Other keys
have specific functions when entered alone or with the SHIFT key. Due to the four-second delay of the
SHIFT function, entry of B, C, or D will cause undesired results. When entering digits, the pointer will
advance automatically as numbers are entered or it may be advanced during entry using the CHANNEL
knob.
After the complete number is entered, press
D
(no SHIFT) to send the number. A
icon will appear in
the display indicating that the tones are being sent. If the other radio receives the call, it will automatically
answer back (transpond) with a short tone, then “ring” several times to signal the operator. That operator
may then answer the call. If the other radio receives the call (transponds) but does not answer, you may
redial by pressing
D
.
3.4.14 RECEIVING A CALL
If another party calls you, your decoder will unmute the speaker and the radio will “ring” several times. To
answer, press the PTT button and speak. The decoder will automatically reset after a short time.
In 5Tone systems, the radio may be programmed to display the identity of the caller.
3.5 SPECIAL KEYPAD FUNCTIONS
The main function of the keypad is to enter digits for selective calling. However, the keypad is also used
to control many radio functions by pressing keypad buttons within four seconds after pressing the SHIFT
key. For some functions, the SHIFT is not required.
SHIFT, POWER ON
Firmware and Software Identification
If the SHIFT is held when the radio is turned on, the display will indicate the firmware version and the
software required for programming the radio. For example
PRG 6KEN
indicates that firmware version
6KEN is installed in the radio and that 6KEN software must be used for programming. This version
contains the features covered by this manual. If another version is indicated, that software must be
available for programming.
NOTE:
In all cases where the SHIFT key is used to control another function, it is not necessary to hold
the SHIFT key. Press it and you have four seconds to press the next button. The first arrow will appear
at the top of the display during this time.
SHIFT
,
1
Display Brightness
Toggles the display backlight from bright to dim.
SHIFT, 2
HIGH/LOW Power Selection
If enabled during programming, selects HIGH or LOW) power. When on HIGH power, a
>
icon will appear
in the display.
SHIFT,
3
Select Call Number Memory
Selects one of the 10 Encode Memory Registers M0 to M9 that are used to store frequently called
numbers for selective calling. Numbers are entered during programming. To recall a number, press
SHIFT,
then
3
and rotate the CHANNEL knob. Each number will be displayed in sequence. To send the
displayed number, press
D
. A
will appear in the lower edge of the display while the tones are being
sent.
SHIFT, 4
Single Tone Function
Turns the SINGLE TONE function ON or OFF.
