
- 11 -
Turn on the Beverage Cooler and set up temperature
The screen is shown as the following picture:
+
: Press this button once and the temperature increase 1°C.
-
: Press this button once and the temperature decrease 1°C.
: Temperature display.
LIGHT
: Lighting button for LED lamp; it controls the on/off of lamp.
POWER
: On/off button used to turn on/off all load.
Press
LIGHT
and
POWER
together for 2 seconds and you can convert
between fahrenheit temperature and Celsius temperature.
Notice!
The temperature range is 1~10°C OR 4-10°C ,The default temperature of
beverage Cooler is 5°C, and the temperature after power failure will be the
temperature set before the power failure.
To elongate the service life of compressor, please wait for at least 5
minutes before the beverage Cooler is restarted after power failure.
Failure display
If there is failure on the sensor, the screen may display failure code, such
as: E and F. When the screen displays the above-mentioned errors, please
do not disassemble it for check by yourself. You should contact local
after-sales service personnel for repair.
If the temperature in the cooler is too low, it will display “L”.
When the temperature in the cooler is too high, the screen will display “H”
and will flash; under this state, the buzzer will buzz once every one second
until 30 seconds; one minute later, the buzzer will continue to give alarm in the
next 30 seconds; after the alarm is given for three times, it will not give alarm
any more. You can press any key to cancel sound alarm.
When you put a lot of
Beverage
together in the cooler, the temperature in