Midea RG10A(B2S)/BGEF, Manual

Page: 8 / 9

13 14
How To Use The Advanced Functions
When the air conditioner operates under
heating mode with the set temperature of
O O
16 C(60 F), pressing button twice in
O O
one second will activate 8 C(46 F) heating.
The indoor unit display shows FP .
,, , ,
FP function
The Boost function makes the unit work
extra hard to reach your present temperature
in the shortest amount of time possible.
When you select
Boost feature in COOL
mode, the unit will blow cool air with
strongest wind setting to jump-start the
cooling process.
When you select Turbo feature in HEAT
mode, the unit will blow heat air with
strongest wind setting to jump-start the
heating process.
Press the Swing button to start or stop the
horizontal louver auto swing feature.
If continue to press the Swing button, five
different airflow directions can be set. The
louver can be move at a certain range each
time you press the button.
Hold down the Swing button for 2 seconds
will start or stop the vertical louver auto swing
feature.
Boost function( )
Swing function
NOTE:
Silence function
Hold down Fan speed button( ) for 2 seconds
to activate/cancel
Silent mode. Due to low
frequency operation of compressor, it may result
in insufficient cooling and heating capacity
(applicable to the air conditioner with Silent
feature only)
ECO/GEAR function( )
ECO operation:
GEAR operation:
How To Use The Advanced Functions
NOTE: This function is only available under
COOL mode.
Press ECO/GEAR button to enter the energy
efficient mode in a sequence of following:
ECO GEAR(75%) GEAR(50%)
Previous setting mode ECO ......
Under cooling mode, press this button, the
remote controller will adjust the temperature
O
automatically to 24 C, fan speed of Auto to
save energy(but only if the set temperature
O
is less than 24 C). If the set temperature is
O
above 24 C , press the ECO button, the fan
speed will change to Auto, the set temperature
will remain unchanged.
NOTE:
Pressing the ON/OFF button, modifying the
mode or adjusting the set temperature to less
O
than 24 C will stop ECO operation.
Under ECO operation, the set temperature
O
should be 24 C or higher. it may result in
insufficient cooling. If you feel uncomfortable,
just press the ECO button again to stop it.
Press this button to enter the energy efficient
mode in a sequence of following:
75%
(up to 75% electrical energy consumption)
50%
(up to 50% electrical energy consumption)
Previous setting mode
This function is only available under COOL
mode.
Under GEAR operation, the display on the
remote controller will alternate between
electrical energy consumption and set
temperature.
When the unit is off, press and hold
Mode and Swing buttons together for
one second, the louver will open for
a certain angle, which makes it very
convenient for cleaning.
Press and hold
Mode and Swing
buttons together for one second to
reset the louver.
Active Clean Function( )
This function is used to clean the air
conditioner evaporator to prevent frosting.
When this function is turned on, the indoor
unit display window appears CL , after 20
to 45 minutes, the unit will turn off automatically
and cancel Active Clean function.
, ,
,,
Fan
Boost
Fan
Boost