Midea RG10A(B2S)/BGEF, Manual

Page: 7 / 9

11 12
The FOLLOW ME function enables the
remote control to measure the temperature
at its current location and
.
When using AUTO, COOL, or HEAT modes,
measuring ambient temperature from the
remote control (instead of from the indoor
unit itself) will enable the air conditioner to
optimize the temperature around
you and ensure maximum comfort.
send this signal
to the air conditioner every 3 minutes interval
FOLLOW ME function( )
(optional)
SLEEP Function( )
The SLEEP function is used to decrease
energy use while you sleep (and don t need
the same temperature settings to stay
comfortable). This function can only be
activated via remote control.
Note:
The SLEEP function is not available
in FAN or DRY mode.
,
How To Use The Advanced Functions
Press the SET button to enter the function
setting, then press SET button or
Temp or
Temp button to select the desired function.
The selected symbol will flash on the display
area, press the OK button to confirm.
To cancel the selected function, just perform
the same procedures as above.
For the detail, see sleep operation in
USER S MANUAL.
,
, ,
,
,
,
,
,
,
,,
,
,
,
,
,
,
Current
time 1PM
2PM 3PM
4PM 5PM
6PM 7PM 8PM 9PM
Timer starts
Unit turns Unit turns
ON
OFF
6 hours later
8 hours later
Press the SET button to scroll through
operation functions as follows:
Fresh( ) Sleep( ) Follow Me( )
AP mode ( )
g
g
g
1
2
FRESH function( )
(optional)
AP mode( )
(optional)
When the FRESH function is initiated, the
Ionizer/Plasma Dust Collector(depending
on models) is energized and will help to
remove pollen and impurities from the air.
Choose AP mode to do wireless network
configuration.
Example: Setting the unit to turn on after 6 hours, operate for 2 hours, then turn off
(see the figure below)
Your remote display
Timer is set to turn ON
6 hours from current time
Timer is set to turn OFF
8 hours from current time
P
P
ress and hold Boost and Clean
buttons together for five seconds to
lock the keypads. ress and hold
Turbo and Clean buttons together for
two seconds to cancel.
Fan
Boost
If the memory feature is stopped, Of
displays for 3 seconds on the screen.
While the memory feature is activated,
press the ON/OFF button, shift the mode
or power failure will not cancel the Follow
me function.
NOTE: Press and hold Boost button for
seven seconds to start/stop memory
feature of Follow Me function.
If the memory feature is activated,
On
displays for 3 seconds on the screen.