Remark per EMC Directive 89/336/EEC
For to prevent flicker impressions during the start of the compressor (technical process) ,following
installation conditions do apply.
1. The power connection for the air conditioner has to be done at the main power distribution. The
distribution has to be of a low impedance, normally the required impedance reaches at a 32 A
fusing point.
2. No other equipment has to be connected with this power line.
3. For detailed installation acceptance please refer to your contract with the power supplier, if restric-
tions do apply for products like washing machines, air conditioners or electrical ovens.
4. For power details of the air conditioner refer to the rating plate of the product.
5. For any question contact your local dealer.
NOTE
INSTALLATION INFORMATION
2
1. Select the location;
2. Install the indoor unit;
3. Install the outdoor unit;
4. Install the connecting pipe ;
5. Connect the drain pipe;
6. Wiring;
7. Test operation.
To install properly, please read this "installation manual" at first.
The air conditioner must be installed by qualified persons.
When installing the indoor unit or its tubing, please follow this manual as strictly as possible.
When all the installation work is finished, please turn on the power only after a thorough check.
Regret for no further announcement if there is any change of this manual caused by product
improvement.
CAUTIONS FOR THE REMOTE CONTROLLER OPERATION
Please do not throw the remote controller or beat it.
Please use the remote controller within the allowed distance, and keep the transmitter toward the
receiver of the indoor unit.
Please keep the remote controller more than 1m away from TV or stereo set.
Never put the remote controller at the place with humid or direct sunlight, or near heaters.
Please insert the batteries properly.
INSTALLATION ORDER
Summary of Contents for MCA-24CRN2
Page 22: ...A CS0174N ...
