1. Top board
2. Control panel
3. Door
4. Front panel
5. Side panel
6. Filter
7. Flexible duct
8. Power plug
9. Switch
10. Drum
• The dryer uses alternative current with a rated voltage and frequency. When
the voltage fluctuates between 6% of the rated voltage, the dryer can work normally.
• Connect the power plug to a socket that is properly installed and earthed.
• Power plug must match the socket and NEVER USE PLUG ADAPTORS!
• Do not use extension cords.
• Do not connect or pull the plug, with wet hands.
• When connectiong and pulling the plug, hold the plug tightly and then pull it out.
Do not pull the power cord itself.
Step 1:
Dryer should be placed in a ventilated area with not
less than 10 cm distance from the wall. If placed in a room
such as bathroom, it is suggested that there are no obstacles
within 1.5m infront of the dryer.
Step 2: Horizontal Adjustment
Tie a heavy object on a string and hang it in front and
at the two sides of the dryer. Refer to the figures below.
If A=A and B=B, this means that the dryer is already level.
Note:
It the installation of the dryer is not level, the
unbalance sensor will work and the dryer will
stop working at times.
Notes when installing:
• Do not install the dryer in open air or places that are open to rain.
• Do not place the back of the dryer near curtains.
• Do not place the dryer near gas or flammable substances.
Step 3: Flexible duct installation
• Connect one end of the flexible duct (with spiral thread)
to the vent at the back of the dryer. Rotate the duct until
it is tightly secure in place.
• The other end of the flexible duct will be extended toward the outdoor area.
Refer to the following illustrations for the proper installation method.
Installation
Simple installation
Installation
Notes before use
Power source and grounding
Notes
Part name
Please take note of the following safety advice:
1. For home electrical wiring that is buried underground, make sure that these are
not in contact with gas pipes and water pipes and are distinguishable as electrical
in nature.
2. Use a socket with current rating of 10 A and is compliant to national electrical
standards.
The socket and the ground wire must be installed by an electician to prevent
incorrect installation or socket selection and to guarantee the electrical safety.
The power cord of the dryer employs a Y connection. If the supply cord is
damaged, it must be replaced by the manufacturer, its service agent or similar
qualified persons in order to avoid hazards.
Heavy object
