16
ENGLISH
A. DAILY STARTUP PROCEDURE
3. Turn the "CONVEYOR"
(
) switch to the ON
("I") position.
4. If necessary, adjust the
conveyor speed setting
by pressing the
or
pushbuttons on the con-
veyor speed controller to
change the displayed
bake time.
6. Turn the "HEAT" (
)
switch to the "ON" ("I")
position.
Check that the "1" light
illuminates. This shows
that the burner or heating
elements have been
turned on.
The "2" light will illumi-
nate while the oven heats
to its minimum normal
operating temperature of
200°F/93°C.
B. DAILY SHUTDOWN PROCEDURE
II. NORMAL OPERATION - STEP-BY-STEP
SECTION 3 - OPERATION
2. Turn the "BLOWER"
(
)
switch to the ON ("I")
position.
5. Press the
or
pushbuttons on the digi-
tal temperature control-
ler to adjust the set tem-
perature, if necessary.
Note that the set tempera-
ture is shown in the lower
window of the display,
while the actual oven
temperature is shown in
the upper window.
1. Check that the circuit breaker/fused disconnect is in the on
position. Check that the window (if so equipped) is closed.
or
Actual
temp
Set
temp
7. Wait for the oven to heat to the set point temperature. Higher
set point temperatures will require a longer wait. The oven
can reach a temperature of 500°F (232°C) in approximately
15 minutes.
8. Allow the oven to preheat for 10 minutes after it has reached
the set point temperature.
Heating
elements on
Oven
temperature
under 200°F/
93°C
1. Turn the "HEAT" (
) and
"CONVEYOR" (
)
switches to the "OFF"
("O") position. Open the
window (if so equipped)
to allow the oven to cool
faster.
2. Turn the "BLOWER"
(
)
switch to the "OFF" ("O")
position. Note that the
blowers will remain in
operation until the oven
has cooled to below
200°F (93°C).
3. After the oven has cooled and the blowers are off, switch the
circuit breaker/fused disconnect to the off position.
or
IMPORTANT
On gas ovens, if the "HEAT ON" light will not illuminate, OR
if the oven does not heat, the gas burner may not have lit.
Turn the "HEAT" (
), "BLOWER"
(
)
, and "CONVEYOR"
(
) switches to the "OFF" ("O") position. Wait for AT
LEAST FIVE MINUTES before restarting the oven. Then,
repeat the Daily Startup procedure.
CAUTION
In case of power failure, turn all switches to the OFF ("O")
position, open the oven window, and remove the product.
After the power has been restored, perform the normal
startup procedure. IF THE OVEN WAS SWITCHED OFF
FOR LESS THAN 5 MINUTES, WAIT FOR AT LEAST FIVE
MINUTES BEFORE RESTARTING THE OVEN.
No attempt should be made to operate the oven during a
power failure. In gas ovens, the burner will not operate
and gas will not flow through the burner without electric
power.
