Middleby Marshall CTX DZ26T Domestic, Owner'S Operating & Installation Manual

Page: 24 / 62

SECTION 3
OPERATION
24
Control Panel
III. STEP-BY-STEP OPERATION
A. Daily Startup Procedure
1. Check that the circuit breaker/fused disconnect is
in the on (closed) position.
2. Turn the on/off switch on. The screen lights up and
first displays the software revisions levels for the
User Interface (UI), Input/Output (I/O Board), and
Motor Control (MC) software. Then the screen
shows a large on/off button, along with Setup and
Info.
3. Touch the large onscreen on/off button. The
screen shows either the Manual Mode touch
screen or the Preset Mode touch screen,
depending on the mode the oven was in when last
turned off. See Figure 18. The screen will show
“Not Ready” at the upper right until the oven heats
to the displayed temperatures and the conveyor
reaches the displayed speed.
NOTE: If the touch screen is in Manual Mode and you
want to operate in Preset Mode, touch and hold the
Presets button for 1 to 2 seconds. If the touch screen
is in Preset Mode and you want to operate in Manual
Mode, touch and hold the Manual button for 1 to 2
seconds.