Middleby Marshall CTX DZ26T Domestic, Owner'S Operating & Installation Manual

Page: 21 / 62

SECTION 2
INSTALLATION
21
III. ELECTRICAL CONNECTION
INFORMATION FOR DZ33T/DZ26T-
SERIES OVENS
WARNING
Authorized supplier personnel normally
accomplish the connections for the ventilation
system and electric supply, as arranged by the
customer. Following these connections, the
factory-authorized installer can perform the
initial start-up of the oven.
Check the oven data plate (Figure 16) before making
any electric supply connections. Electric supply
connections must agree with data on the oven data
plate.
NOTE: The electric supply installation must satisfy the
requirements of the appropriate statutory authority,
such as the National Electrical Code (NEC),
ANSI/NFPA70, (U.S.A.); the Canadian Electrical
Code, CSA C22.2; the Australian Code AS/NZ5601; or
other applicable regulations.
A fused disconnect switch or a main circuit breaker
(customer furnished) MUST be installed in the electric
supply line for each oven; it is recommended that this
switch/circuit breaker have lockout/tagout capability.
The electric supply connection must meet all national
and local electrical code requirements. Copper is the
recommended material for the electrical supply
conductors.
DOMESTIC & INTERNATIONAL CE PLATE
Typical Oven Data Plate