I- 00162 Page 3 of 7
7) Using 2 preliminary mounting holes and installer's choice
of hardware, attach the SRSR base to millwork
(See FIGURE B). Remove the “Locking Trim Panel” and
carefully test the sliding operation of the system.
To close, use lockout lever. Should interference in the
millwork occur it may be necessary to fine tune the
mounting location (simply loosen the preliminary
mounting points and adjust as necessary).
8) Using the preliminary mounting screws for support, extend
the sliding carriage to the outer most position. Finish
attaching the base to the host enclosure using
customer-supplied hardware. (See FIGURE C on pg. 4 for the
correct number of mounting points required per application)
VERY IMPORTANT - Use all the mounting points designated
when affixing the base to the host enclosure.
9) Slide rack into closed position and attach
the locking trim panel.
NOTE: When fully extended, a lockout feature secures the
rack in open position.
Removal of rack from base: To remove, extend rack
and remove the four wing nuts on bottom of frame.
Pick up rack lifting from the sides using handles
provided. To reattach, extend slides and lift rack
onto rotating base aligning studs on rack with
holes on base. (Rack should click in securely)
Install four wing nuts from the underside of
base and tighten.
SRSR RACK REMOVAL
INSTRUCTIONS
WING NUT
Preliminary
mounting
holes
FRONT
FIGURE B
BOTTOM
PAN
LOCKING
TRIM PANEL
SQUARING
PANEL
REAR
RACKRAIL
FRONT
RACKRAIL
HANDLE
ROTATING
TAB
LOCKOUT
LEVER
